Gilderflukeco BR-MultiBrick32 Manual do Utilizador descarregar pdf (Página 35)

2) Disable When Stopped: When this switch is ON, then all

of the outputs will be returned to an ‘off’ state when a show

is not being run. If this switch is OFF, then the last frame of

data will be retained on the outputs until a new show is run

or the BR-MultiBrick32 is reset.

3) Use DMX-512 Checksum: When this switch is ON, this

switch tells the BR-MultiBrick32 to use the optional checksum

transmitted from all Gilderfluke & Company equipment be-

fore updating the outputs. This will keep any outputs from

being updated with data that has been corrupted in any

way. You should always leave this switch ON if operating

from Gilderfluke & Company equipment.

4) Record Forever! (Revision 1.03 to 1.99 Firmware Only):

When ON, this switch forces the BR-MultiBrick32 permanent-

ly into ‘Record’ Mode. Use this switch in applications where

you need the BR-MultiBrick32 to boot up listening to data

coming into it on the RS-422 Port.

5) Dipsw5: off on off on off on off on

6) Dipsw6: off off on on off off on on

7) Dipsw7: off off off off on on on on

9600 2400 4800 9600 19.2K 38.4K 57.6K 115K

Baud Baud Baud Baud Baud Baud Baud Baud

2.00 and later revision BR-MultiBrick32s will allow you to

change the baud rate used for the RS-422 serial port using

Dipswitches 5 through 7. Only baud rates of 2400, 4800

and 9600 are valid at this time. If you want to use the BR-

MultiBrick32 with PC•MACs or GilderTerm, you must leave

the baud rate set to the default 9600 baud.

8) Write Protect Switch: When this switch is ON, the BR-

MultiBrick32 will protect the onboard flash memory from ac-

cidental alterations. With the switch in the ‘off’ position,

reads and writes can take place normally.

This switch must

be in the ‘off’ position for shows to be downloaded to the

BR-MultiBrick32.

With the memory write protected, the BR-

MultiBrick32 should retain whatever has been programmed

into it for at least forty years.

d) 'Smart' Brick/'Dumb' Brick Select: This switch tells the BR-

MultiBrick32 whether the BR-MultiBrick32 is going to be acting like

a ‘Dumb’ Brick or a ‘'Smart' Brick’. When acting as a ‘Dumb’ Brick,

GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX 818/840-9485

AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX 407/354-5955

29 of 36

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42

Comentários a estes Manuais

Sem comentários

Gilderflukeco BR-MultiBrick32 Manual do Utilizador Página 35

Comentários a estes Manuais

Manuais e produtos relacionados com Áudio Gilderflukeco BR-MultiBrick32