Gilderflukeco C-50 Trans Manual do Utilizador descarregar pdf

C-50Trans Transition Connector

(Sd-50/40)

The C-50Trans is a convenient way to attach discrete wires to a Sd-50/xx for the

forty digital (on/off) Show Control Outputs. It attaches right to the top of a Sd-50/40. It

also provides convenient connections for up to eight model airplane-style PWM Ser-

voMotors.

You install a C-50Trans by:

1)! Locating the threaded mounting holes in the case top of the Sd-50/40. Position the C-

50Trans on the top of the case by plugging it into the forty position J-6 connector. It has

a polarizing ‘bump’ on one side, so it will only go in the correct way. Use a pin or other

pointy object to poke a hole through the Sd-50/40’s label at each of the four mounting

holes. Remove the C-50Trans from the Sd-50/40. Use an X-acto or other sharply

pointed knife to remove the label where it covers the threaded hole beneath. You only

need to expose the hole. No additional label material around the hole should be re-

moved. Be careful not to damage the threads as you remove the label.

Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840–9484 • 800/776–5972 • fax 818/840–9485

East Coast/Florida Office • 7041 Grand National Drive • Suite 128d • Orlando, Fl. 32819 • 407/354–5954 • fax 407/354–5955

C-50Trans Manual / June 12, 2007 10:28 AM / page 1 of 2

1 2

C-50Trans Transition Connector(Sd-50/40)The C-50Trans is a convenient way to attach discrete wires to a Sd-50/xx for the forty digital (on/off) Sho

2)! Install the four 4–40 x ¼” tall male/female spacers into the four mounting holes in the top of the Sd-50/40. To make them the required 5/16”

Sem comentários

Gilderflukeco C-50 Trans Manual do Utilizador