Gilderflukeco BR-MultiBrick32 Manual do Utilizador descarregar pdf (Página 24)

Preparing Animation Data for AutoDownloads

The Eprom Memories used for the original 'Brick' products manufactured

by Gilderfluke & Company each contained one channel (eight-bits) worth

of data. Later products used Eproms which contained several channels

each. The Flash Memories used on the BR-MultiBrick32, BR-ANA, BR-EFB and

BR-SmartMedia use a MultiChannel format with a complex header to allow

them to be AutoDownloaded from PC•MACs.The following instructions apply

to all of cards that use AutoDownload files.

After you have finished programming your show(s), files are AutoDown-

loaded from PC•MACs by:

1) Selecting the 'Save as AutoDownload...' command from the 'File'

pulldown.

2) Use the ‘Add’ button to select any additional show(s) you would

like to be saved into this AutoDownload file.

3) Use the ‘Promote’ and ‘Demote’ buttons to move selected show(s)

into the order you would like to save them in the Flash Memory.

4) Select the ‘first show’ and what will happen to the BR-MultiBrick32

on power up. If you will be operating the BR-MultiBrick32 as a 'S-

mart' Brick, then set the power up action to ‘wait’. If you have set

the BR-MultiBrick32 to ‘wait’ at power up, then the first frame of

the show you have selected will be output as soon as power is ap-

plied to the BR-MultiBrick32.

5) Set what will happen on each of the four ‘J8’ optoisolated inputs if

you will be operating the BR-MultiBrick32 as a 'Dumb' Brick. You

can ignore these settings if you will be running it as a 'Smart' Brick.

6) Select each show to be downloaded one at a time and set what

will happen at the end of each show and whether it can be

‘stepped on’ if you will be operating the BR-MultiBrick32 as a 'Dum-

b' Brick. You can ignore these settings if you will be running it as a

'Smart' Brick. When operating as a ‘Dumb’ Brick, any show which

can be stepped upon can be interrupted mid-show by a new

show start coming in. Any show which can not be stepped upon

will ignore all additional start commands while it is still playing.

7) Set the ‘Brick Serial Address’ to send the AutoDownload file to. This

is the serial address of the card you want it to be received by. All

other cards will ignore the data being sent to this one card. With

BR-MultiBrick32s, the address is usually the same as the ‘start’

channel set in the next step.

GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX 818/840-9485

AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX 407/354-5955

18 of 36

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Sem comentários

Gilderflukeco BR-MultiBrick32 Manual do Utilizador Página 24