Gilderflukeco old MACs 8 bit Digital Audio System Manual do Utilizador descarregar pdf (Página 59)

SWITCH 1 = LOOP ALL SPIELS (1 = ON)

SWITCH 2 = CLOCK ENABLED (1 = ON)

SWITCH 3 = SELECT SPIEL FROM AUX PORT (1 = ON)

SWITCH 4 = PARITY ENABLED (1 = ON)

SWITCH 5 = MUTE AUDIO WHILE STOPPED (1 = ON)

SWITCH 6 = JUMP FORWARD ON EARLY STARTS (1 = ON)

SWITCH 7 = BANK EARLY STARTS (1= ON)

SWITCH 8 = GO BACK ON EARLY STARTS (1 = ON)

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥

Reset to Default Configuration

This switch should only be used when an Audio Repeater wonÕt boot for love or money. When

Dipswitch one, switch 2 is turned on when the card is powered up, the card will revert to the default

configuration. This will allow you to bring up a card when the configuration has been scrambled to such

an extent that it wonÕt let the card boot. This default configuration, although loaded into RAM, wonÕt be

transferred into the EEPROM until you perform any action which will save the memory. These include

eXiting the serial port configuration mode (answering ÔyesÕ when asked if you want to save the

configuration), or doing any of the dipswitch configuration commands.

Be sure to turn this switch back off when you are through with it. Otherwise it will load the default

configuration every time the card is powered up.

GILDERFLUKE & C

. ¥ 205 SOUTH FLOWER ST. ¥ BURBANK, CALIF. 91502-2102 ¥ 818/840-9484 ¥ FAX 818/840-9485

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 109 110

Sem comentários

Gilderflukeco old MACs 8 bit Digital Audio System Manual do Utilizador Página 59